Purpose of the guide

This guide will show you where to find the quality settings for your bird box camera on a Windows or Mac computer using CMS5/VMS.


Before you begin

Make sure that your bird box camera is connected to the internet, and that you have added it to your computer.


Some of these settings will not be available, depending on the model of camera you have.


TABLE OF CONTENTS

Finding the quality settings


Open up CMS5 and click on 'Device Config'


Now click on the arrow next to 'Default Group' in the panel on the left side, select the IP address, serial number or name of your camera, and then click on 'Encode Config' when the icons light up.


Meaning of the settings

When you click on Device Config you will be presented with the screen below.


Main Stream and Extra Stream

Main stream is the high quality version of the video feed. Extra stream is the low quality version for low bandwidth connections or small screens. These settings are shown as 'UHD/HD' and 'SD' on the mobile app, for high definition and standard definition.


Compression

This is the type of format the videos will be recorded in. H.265 is newer and uses less space, but it is harder to convert into a usable video format so it is highly recommended that you set it to H.264 if the option is there.


Resolution

This is the size of the videos that will be produced. A higher resolution image means the video will look better on large monitor screens or TV's, but it will also use more bandwidth and take up more storage space.


Quality

This is how sharp the image will be when produced by the camera. Higher quality means a better image but will also use more bandwidth and take up more storage space.


FPS

This is the number of frames per second of video, higher FPS will create a better image but will also use more bandwidth and take up more storage space.


Stream Control

CBR/Constant bit-rate: The bit-rate will be kept consistent, causing the video quality to vary.

VBR/Variable bit-rate: The quality of the video feed will be kept consistent, causing the bit-rate to vary.


Bit-rate (Kb/s)

This is the number of kilobytes the device will use per second, and is determined by the other settings. If you set the quality settings to maximum, the bit-rate will increase also. 


If you are concerned that your bit-rate is too high then run a speed test on your computer, make a note of the upload speed and compare this to your bit-rate (your upload speed will likely be shown in MB, whereas the bit-rate is shown KB, so be aware that 1024KB is equal to 1MB). Make sure that the bit-rate does not exceed the upload speed, and if many people use the same internet connection as you make sure it is significantly below.


I Frame Interval

All you need to know is if you expect the video to have a lot of motion, set this higher but be aware it will increase the bandwidth and storage used. If you expect the image to be mostly still, set this to 1. For a full definition, see here. 


Video/Audio

This allows you to disable audio for the main stream, or video/audio for the extra stream.


Static Encode Config

High Profile: Set to high profile if the feed will mostly be viewed from larger screens.

Main Profile: Main profile is intended for medium sized screens and larger phones.

Baseline: Baseline profile is intended for very small screens. 


H264+ Enable

If you want to change the VBR/CBR setting, disable this setting.


Next Steps

We hope you have found this guide useful. If it has not answered your question you can see related articles on the right or raise a ticket.